Cleaning bathtub with vinegar and baking soda is an excellent option to get rid of dirt quickly without the use of professional expensive household chemicals. This method will help clean the bathtub and eliminate unpleasant odors in the drain pipe.
Effectiveness of Cleaning Bathtub With Vinegar And Baking Soda
The walls of the bathtub are deposited with a coating of dirt: rust, salt, lime, residues of cleaning agents, shower gel, soap. You can use baking soda and vinegar to remove dirt from the bathtub. Thanks to these components, fresh stains and plaque are removed, the enamel is not damaged. The surface is disinfected from pathogens.
Vinegar will do a great job on old rusty marks that are problematic to remove. Using two tools at hand will make the bathtub shine as if it was purchased.
Recommended for you How To Make A Dull Acrylic Bathtub Shine?
baking soda Vs soda ash for Cleaning Bathtub
Before starting cleaning procedures, you should determine the nature of the stains in order to select the right sodium bicarbonate. Baking soda is a safe, mildly alkaline cleaning agent for bathtubs where there is little dirt. The product is applied to contaminated areas, left for about 1 hour, and then wiped with a sponge. The powder does not harm steel and cast iron coatings, gently affecting stains. The use of this substance does not cause allergic reactions in humans.
Soda ash is often used in household management – a strong alkali that will clean old and stubborn stains. The pigment is diluted with water, then the dirt is smeared with the resulting mixture, left for 30 minutes, washed off with warm water.
Cleaning Bathtub With Vinegar And Baking Soda Step-By-Step
Scrubbing the tub with baking soda and vinegar will help remove stubborn stains.
- The first step is to sprinkle the bath with powder.
- After that, you should dilute the table vinegar essence with water. Collect liquid in a spray bottle and spray over the surface. Leave in this state for about 15 minutes.
- As a result, a chemical reaction will be observed in which bubbles appear.
- Now you need to take a soft sponge and gently grind the mixture, leave again for 15 minutes.
- At the final stage, rinse with water and wipe with a cloth.
It is strictly forbidden to use in addition abrasive cleaning agents, rub with hard sponges, washcloths and brushes.
If there is no vinegar in home for cleaning bathtub
It happens that there is no dining room vinegar essence at home, then methods using additional components with baking soda are allowed.
Soda and citric acid
Citric acid in combination with sodium bicarbonate will help remove dirty plaque. First, a soda solution is applied to the surface of the bath for 20 minutes, then washed off with warm water with diluted citric acid. They use exclusively baking soda, which does not spoil the material. Personal protective equipment (latex gloves, goggles, respirator) should be used to avoid irritation.
Be sure to thoroughly remove the remains of the cleaning mixture so that they do not get into the bath during water procedures.
Cleaning Bathtub With Soda Ash
Washing your bath with soda ash is a great solution to remove heavy fat and limescale deposits. The substance is used in combination with bleach. Take two tablespoons of baking soda and soda ash, add a small amount of water. Stir until a homogeneous gruel, which is smeared with a bath for 15 minutes. After that, mix 0.5 cups of vinegar and bleach. The resulting slurry is applied in the next layer, left for 30 minutes. Then wipe with a soft sponge and rinse with running water.
Soda and laundry soap
An ambulance for cleaning the surface of tiles, bathtubs washing paste based on baking soda and laundry soap. The recipe includes: 100 g of soap, 100 ml of warm water, 75 g of powder. A paste is prepared by dissolving soap and soda in a liquid.
soda and ammonia
You can get rid of the dirty bathtubs with soda and ammonia. A cleaning solution is prepared, which is rubbed into the bath cloth, and left for about an hour. This procedure will relieve the bathtub from yellow streaks and rust.
Check Best ways for Cleaning Pipe With Vinegar And Baking Soda.
Bleach with baking soda
Whiteness, which is used after cleaning the bath with soda, will help to enhance the cleaning properties of sodium bicarbonate. The substance is applied to the cast iron cloth for half an hour. It is not recommended to apply this technique more than three times a month. Bleach contains harmful chemicals that can be harmful to your health.
ammonia is mixed with hydrogen peroxide
A simple pharmacy antiseptic, hydrogen peroxide will remove yellowness from plumbing items. The condition is to mix the components exclusively in clean glass containers using personal protective equipment. The ammonia is mixed with hydrogen peroxide in equal proportions at the rate of 2: 1. The sponge is moistened in liquid and smeared with cast iron, left for 15 minutes, rinsed with water.
how to unclog a bathtub drain with Baking soda and vinegar?
It happens that you need to clean the drainpipe of bathtub from the blockage yourself. To do this, all components are poured into the pipe in the following sequence:
- 0.5 cups of Baking soda and table vinegar essence.
- After that, close the drain hole with a stopper, leave it for about 2 hours.
- Then we pour out the hot water and wait a little more until the chemical cleansing process is completed.
There are several other methods for cleaning drain pipes of bathtubs. The first step is to clean the pipe of debris, pour boiling water in the amount of one liter. Leave for 30 minutes, then clean the equipment with a plunger. The powder is taken in a ratio of 1: 3. This technique will disinfect the bathtub. If the blockage is severe, the cleaning procedure must be repeated.
Check Other Guides on Topics
Conclusion
The timely removal of fresh stains in a safe way will extend the life of your bathtub. Use any suitable method for cleaning bathtub with vinegar and baking soda from the above remedies. If you have no vinegar at home you can use other household things with baking soda for cleaning purposes.
